A Gray Foamed Acrylic adhesive with a special composition giving excellent all around bonding properties and unique characteristics that allows for very high performance in the most demanding of applications. The pressure sensitive acrylic composition provides for very good tack, excellent adhesion to variety of surfaces and high shear strength performance. Tape is carried on a Red, release coated Polyethylene Liner that is easily removed.
Unit of Measure

Specifications

Material

N/A Acrylic Foam

Color

N/A Gray

Industry Focus

N/A Transportation

Physical Properties

Construction

N/A Gray Foamed Acrylic with Red Polyethylene (PE) Liner

Thickness (Excluding Liner)

N/A 1.1 mm43.3 mil

180 Degree Peel Adhesion Strength

N/A 8.7 lb/in

Tensile Strength (T-Block Test Alum)

N/A 85 lb/in²

Dynamic Shear at Room Temperature After 24 Hours (h)

N/A 85 lb/in²
Short Term Temperature Resistance (Elevated)1 N/A Up to 320 ºF
Long Term Temperature Resistance (Elevated)2 N/A Up to 212 ºF

Cold Temperature Resistance

N/A Down to -40 ºF

Ultraviolet (UV) Resistance

N/A Good

Applications

Applications

N/A
  • Ideal for structural bonding applications in the transportation industry - i.e. fixing body and roof panels in the bus and truck industry. Used in automotive aftercare market and in body shops for crash repair as well as mounting/fixing car side molding and emblems.
  • Used as a mounting tape in the illuminated sign industry, for fabricating road signs, joining of metals and plastic trims in furniture construction and architectural applications.

How to Apply for Best Adhesion Results

How to Apply for Best Adhesion Results

N/A
  • Surfaces to be bonded must be clean, dry, and free from dust and loose particles. Preferably use a solvent (IPA) to prepare surface.
  • Must apply sufficient pressure to tape to ensure adhesive "wet-out". Bond strength builds with dwell time - optimum strength achieved after 24 hours.
  • Low energy surfaces such as plasticized plastics may require a primer to surface to ensure strong bond.

Note

Note

N/A The physical properties listed above are typical test results obtained from a series of laboratory tests and should not be used for the purpose of writing specifications. Before using this product, user shall determine the suitability of the product for his/her use; and user assumes all risks and liabilities in connection therewith. All test procedures used are in accordance with ASTM and PSTC methods
  • 1 4 hr. at max temp with 500 gm load
  • 2 166 hr at max temp with 1 kb load