Product is of superior quality, with a long shelf-life, and "write-on" capability. It provides a very effective vapor and moisture barrier. It is highly conformable and resistant to aging, sun, water, fungus, bacteria, oil, acids, alkalies and corrosive chemicals. It provides good abrasion, impact and rupture resistance.
Unit of Measure
Specifications
Length |
N/A 36 yd60 yd |
Backing Material |
N/A Matte Surface Soft Polyvinyl Chloride (PVC) |
Adhesive Material |
N/A Synthetic/Natural Rubber Resin Blend |
Film Thickness |
N/A 4.73 mil0.12 mm |
Adhesive Thickness |
N/A 1.26 mil0.032 mm |
Total Thickness |
N/A 6 mil0.15 mm |
Adhesion |
N/A 22 oz/in |
Tensile Strength |
N/A 16 lb/in |
Elongation at Break |
N/A 150 % |
Temperature Resistance |
N/A -20 to +176 ºF |
Moisture Absorption |
N/A Less than 1.5 % |
| Moisture Vapor Transmission1 | N/A Less than 2.5 % |
Corrosion of Copper, Brass, Steel, and Aluminum |
N/A None |
| Accelerated Aging Factor2 | N/A Greater than 100 % |
Government Specifications |
N/A Conforms to AA-1689B, Type II (meets cancelled spec PPP-T-66E,Type I, Class 2) |
Color |
N/A Black Clear (Translucent) Dark Blue Dark Brown Emerald Green Gray Kelley Green Light Green Medium Blue Medium Brown Orange Purple Red Sky Blue White Yellow |
Industry Standards / Certifications for Color |
N/A Occupational Safety and Health Administration (OSHA) |
Note for Color |
N/A Medium Brown, Medium Blue, and Light Green stocked in 36 yd length only. |
Intended Applications |
N/A Wrapping |
Applications
Applications |
N/A Used for color coding; lane marking and safety coding to meet OSHA requirements; decorating, striping on vehicles, boats, sporting equipment, etc.; masking of printed circuit boards; harness and pipe wrapping; duct and joint sealing. |
Note
Note |
N/A The physical properties listed above are typical test results obtained from a series of laboratory tests and should not be used for the purpose of writing specifications. Before using this product, user shall determine the suitability of the product for his/her use; and user assumes all risks and liabilities in connection therewith. All test procedures used are in accordance with ASTM and PSTC methods. |
- 1 Gm/100 sq in/24 hrs
- 2 % of original adhesion to backing after aging
